![]() ![]() If you dual-boot with Windows, Windows will handle daylight savings time for you. in case of a multi boot with a Windows system, which assumes the hardware clock runs in local time. However, this mode is probably better supported than the UTC option in Windows. The real-time clock can use either UTC or local time. The problem with dual booting is that Windows uses local time on a hardware level, while Linux uses UTC time (aka GMT time). The command warns you that this mode is not fully supported and can cause some problems when changing between time zones and with daylight savings time. If you see “RTC in local TZ: yes”, Linux is set to use the local time zone instead of UTC. To check your current settings, run: timedatectl timedatectl set-local-rtc 1 -adjust-system-clock Linux will store the time in local time, just like Windows does. Run the following command to put the real time clock on the motherboard into local time. To make this change, first open a Terminal window on your Linux system. This will work on modern versions of Ubuntu, Fedora, Red Hat, Debian, Mint, and other Linux distributions that use systemd. Im dual booting Windows 7 Ultimate (64-bit) on a seperated partition from. ![]() The steps to make your Linux system use local time can vary from Linux distribution to Linux distribution. However, on any Linux distribution with systemd, you can use the timedatectl command to make this change. PCI passthrough allows you to use a physical PCI device (graphics card. It’s also incompatible with Windows’ own Internet time-syncing service. Windows does have a registry setting that forces it to store the time as UTC, but it reportedly isn’t well supported and can cause problems with some third-party applications that always assume the hardware clock is in local time. Making Linux use local time the same way Windows does is probably the best option. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |